A modern classic: The Altendorf WA 8 NT with manual rise/fall adjustment of the main saw blade.
Providing accurate, clean cuts and easy to operate, the Altendorf WA 8 NT is the ideal machine for cutting panels to precise dimensions. The control panel is simple to use and both the rip fence and the crosscut fence are easy to set up.
The Altendorf WA 8 is not available in all markets.
The standard equipment of the machine may vary from country to country.
Equipment
Standard Equipment
Manual rise/fall adjustment of the main saw blade, non-tilting saw unit
Sliding table length 2 000, 2 600, 3 000 or 3 200 mm
Rip fence with manual adjustment, cutting width 1 000 or 1 300 mm
Crosscut fence, crosscuts to 3 200 mm- Motor rating 5.5 kW (7.5 HP), with three speeds 3/4/5 000 rpm, manually adjusted
- Cutting height max. 82 mm
Machine frame control panel
Extraction hood
Machine frame
Saw Unit
Optional Equipment
Technical data
Space requirements
Your WA 8’s space requirements are as below: | ||
A | Sliding table length + 290 mm |
|
B | Sliding table length + 360 mm | |
C | Crosscut fence, stops to 3 200 mm: 1 800 – max. 3 350 mm | |
D | Cutting width + 310 mm |
|
Machine weight | ||
1 100 kg | ||
Table height | ||
910 mm | ||
DUST EXTRACTION CONNECTIONS
Top connection: | small extraction hood: Ø = 50 mm, |
Bottom connection: | Ø = 120 mm |
Pressure drop: | 1 500 Pa with a total connection diameter, Ø = 140 mm |
Minimum air requirement: | Vmin = 1 150 m3/h at 20 m/sec. |
ELECTRICAL POWER REQUIREMENTS 3)
Motor (kW) | 5.5 |
Voltage (V) | 380 - 420 |
Frequency (Hz) | 50 |
Current (A) without/with scorer | 11,5/13,5 |
Fuses/circuit breakers (A) | 25 |
3) The cross section of the mains cable depends on the machine’s distance from the power source and must be determined by a qualified electrician (Power drop in the input cable ≤ 3 %). Please contact your Altendorf sales partner if your power supply does not match the requirements shown.
CUTTING WIDTHS
CUTTING WIDTHS (mm) | 1 000 | 1 300 |
Cutting heights
With or without scoring saw blade | |||||||
Saw blade diameter (mm) | 250 | 300 | 315 | 350 | 400 | ||
Cutting heights, vertical (mm) | 0-50 | 0-75 | 0-82 | 0-100 | 0-125 | ||
Cutting heights at 45° (mm) | 0-33 | 0-50 | 0-56 | 0-70 | 0-87 | ||
Doppelrollwagen-Schnittlängen
Maximum cutting lengths when using clamping shoe or crosscut fence |
| |||||||
Table length (mm) | 2 000 | 2 600 | 3 000 | 3 200 |
|
|
|
|
Cutting length (mm) | 1 905 | 2 505 | 2 905 | 3 105 |
|
|
| |
|
| |||||||
Brochure