Ergonomic: The Altendorf WA 80 X with three motorised axes.

Number one for ease of operation and ergonomics: The eye level control panel of the Altendorf WA 80 X can be pivoted to the most convenient position for the operator. The rip fence is motorised. Square cuts and mitres are both carried out using the same crosscut-mitre fence.

Equipment

Standard Equipment

Optional Equipment

Technical Data

DUST EXTRACTION CONNECTIONS

Top connection:	small extraction hood: Ø = 50 mm, large extraction hood: Ø = 80 mm
Bottom connection:	Ø = 120 mm
Pressure drop:	1 500 Pa with a total connection diameter, Ø = 140 mm
Minimum air requirement:	Vmin = 1 150 m3/h at 20 m/sec.

ELECTRICAL POWER REQUIREMENTS ³⁾

Motor (kW)	5.5
Voltage (V)	380 - 420
Frequency (Hz)	50
Current (A) without/with scorer	11,5/13,5
Fuses/circuit breakers (A)	25

³⁾ The cross section of the mains cable depends on the machine’s distance from the power source and must be determined by a qualified electrician (Power drop in the input cable ≤ 3 %). Please contact your Altendorf sales partner if your power supply does not match the requirements shown.

Cutting widths

Cutting widths (mm)

800

1 000

1 300

Sliding table cutting length

Maximum cutting lengths when using clamping shoe or crosscut fence
Table length (mm)	2 000	3 000	3 200
Cutting length (mm)	1 850	2 905	3 105
Cutting lengths refer to mechanical travel, i. e. from end stop to end stop on the sliding table.

Depth of cut

With or without scoring saw blade
Saw blade diameter (mm)	250	300	315	350	400
Depth of cut vertical (mm)	0-50	0-75	0-82	0-100	0-125
Depth of cut at 45° (mm)	0-33	0-50	0-56	0-70	0-87

Space requirements

Your WA 80’s space requirements are as below:
A	Sliding table length + 290 mm
B	Sliding table length + 360 mm
C	Crosscut fence stops to 2 500 mm: 1 445 – max. 2 630 mm Crosscut fence stops to 3 200 mm: 1 800 – max. 3 350 mm
D	Cutting width + 310 mm
Machine weight
1 000 kg
Table height
910 mm

Further information

	Operating instructions
	Brochure